Series 100 RO controllers
|
An ideal solution for the monitoring and control of light commercial reverse osmosis units. This economical controller provides relays for the RO pump, inlet solenoid valve, and membrane flush solenoid valve.
The dry contact switch inputs monitor storage tank level, low and high pressure switch signal, and system lockout for pretreatment backwash or regeneration for on/off operation. All inputs and outputs are controlled with time delays for proper operation
Additionally the TDS value incorporates a feild adjustable set point for water quality threshold, allowing the unit to produce a system warning if the water quality threshold is exceeded. LED indicates water quality and operating status.
|
| Features: |
- Economical controls
- Visual status LED
- TDS monitor w/sensor (0-1000PPM)
- 3 digit LED display
- Jumper selectable flush types
- Jumper selectable switch inputs
- TDS calibration adjustment
- TDS set point adjustment
- Quick disconnect high voltage terminals
- Plug in terminals for switch inputs
- Panel mountable enclosure
- Optional wire harness kit
|
|
| Specifications: |
Inputs/outputs switch inputs: |
Control relays: |
-
Power: 102 VAC or 240 VAC, +10 -15% 50/60Hz
-
Enviorment: -22 to 140°F, 0-95% RH, non-condensing
-
Enclosure: 8.25" x 5.0" x 3.0" ABS plastic
|
- Low pressure switch
- RO storage tank full
- Pretreatment lockout
(All switch inputs are jumper selectable NO or NC)
|
- Inlet solenoid valve 120/240 VAC 5A maximum
- RO pump 120/240VAC 1HP, single phase maximum
- Flush solenoid valve 120/240 VAC 5A maximum
|
